[namba209]

As promised here's the pics of the attaching hardware for the dash, as close as I could get the camera to take them. 3 screws on each outside edge, 4 screws at the base of the windshield, I had to take the pic through the windshield, so I marked the locations with masking tape, the two bolts on either bottom of the instrument panel for its removal along with the hole in the dash to acess the pax side. Oh Yeah, there are two more screws for the dash under the heater control panel, easily seen when the instrument panel is removed. Once you disconnect the connector plugs at the fuse panel, remove the ammeter wires and the one from the headlight micros, Gray/Green with spade lugs disconnect, and the other assundry wires that don't go through the fuse panel, the panel should come out, almost. You still have to remove the console panels, at least I have to. The rear panel is held in with 3 screws, the front with the gear shift and headlight lever is held in place with spring clips, two at the rear and two half way toward the front. The headlight lever will have to be removed also, it's held on the shaft by a small screw in the side of the handle. HTH.