Flywheel mounting hole PCD

[lamchop77]

Hi all

Just wondering if anyone has the dimensions for the mounting holes for the CIH flywheel/crank

Need the pcd, hole sizes and the offset angle for the positioning/locator bolt if anyone has them, and any other dimesions come to think of it!!!

Decided to have a crack at machining up my own steel flywheel. I'm maxed out at work so haven't got the time to strip down engines to get accurate measurements.

Also was going to use EN8 or EN24 for the material, does anyone know what the best material to use is??

Thanks

Chris

[juzatheman]

the hole in flywheel 40.5mm and the crank diam..40.4mm about..
material temp about 12*c when measured..

sorry my bad english.
i´am from finland so...