ADDCO rear sway bar hardware problem

[GT Tim]

I tried to put my rear sway bar in my GT and the hardware doesn't look like the right plate.I think it should be an L not flat.If any one can help that would be great.Thanks Tim

[baz]

tim i just did a search for addco and found a thread about them with a photo from gtjim and it has angle iron brackets in the shrink rap card so it maybe you have the wrong ones
do a search and look at it to see

[greensmurf20]

my addco rear bar came with angle iron for the brackets too, i dont see how a flat piece would work as it should, i'd call them and get the right stuff.

[GT Tim]

I saw those pics that is why I figured I would confirm before I call Addco back.Thanks guys that is what I needed to know.Now I can call them on Monday.

[bosco]

I could never get the rear Addco bar to work on my GT. They gave me the angled brackets but the bend in the bar seemed to be in the wrong place. It's been sitting in my garage for two years. The front fit perfectly.

Good Luck.

[GT Tim]

I called today and they said they mistakenly sent me hardware for an MG.Part #901 the GT part#902.They said that they will ship out right away be here by friday at the latest.Just in time to try again.Thanks again guys

[spdkilz02]

which is better if u can only do one? the front or back?

[asdasc]

I was wondering the same thing, Adam! My guess is that the rear would provide the most benefit.

Bosco, you should check the number off it to make sure they sent you the right bar!

If so, I am sure you could sell it to someone here.

[GT Tim]

Finally got the right hardware today! So I put the sway bar in and it looks good.It did take me a little longer than I planned on about an hour.I am not sure which one has the most benifit.I figure do them both.Thanks again Tim

[spdkilz02]

good to hear that u got it in...