Opel GT Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. 4B - Propeller Shaft and Central Joint
    I have finally completed the installation of all the rubber bits in the torque tube center support. I believe they are in correctly, but the torque tube is firmly against the upper stop and there is a 1/2" gap between it and the lower stop. The picture should show this. Is this correct? The...
  2. Group 5 - Brakes
    Installing new brake tubing lines on a half-finished project I bought, but can't seem to find good information on where to route them. I want to make sure I don't interfere with anything in the suspension or transmission tunnel areas. Does anyone have a simple sketch or diagram to help ? Also, I...
  3. 2B - Seats, Windows and Interior trim
    Just looking for advice on the correct sequence of installation. Seems like the regulator and vertical post need to go in first, loosely. Then install the glass into the felt tracks. Slide it down to the bottom. Then position the glass into the lifting bracket with the nylon spacers, etc. Then...
1-3 of 3 Results
Top