Opel GT Forum banner

1 - 2 of 2 Posts

·
Member
Joined
·
257 Posts
Discussion Starter #1 (Edited)
Is there anything special to look for while I take apart this engine? Oil ports, water ports, any hidden valves?
I'm going to be putting in new bearings, rings, head is in the shop getting new valves, seats, seals. Any advice on what to look for would be very helpful. I'm not looking to modify this engine just replace what is needed to get it running. It has a new waterpump and new Weber Carb. I'll send picture when I start putting it back together.

Also, I just purchase a new gasket set for this engine and in a little package with the oil pump gasket was a round felt piece.
Can anyone tell me what this is?

Thanks,
Stanley P
 

·
Super Moderator
Joined
·
13,576 Posts
Stanley_P said:
Also, I just purchase a new gasket set for this engine and in a little package with the oil pump gasket was a round felt piece.
Can anyone tell me what this is?

Thanks,
Stanley P
The felt piece should be for a Kadett dipstick seal. If you don't have a Kadett oil pan/dipstick, then it is not applicable.

Bob
 
1 - 2 of 2 Posts
Top