1970 Kadett 1.1 Cam Bearing #s
1 - 3 of 3 Posts
Joined
·
5,564 Posts
Opel Numbers
The Opel Parts book lists the bearings seperately ( no kit!) and they are "unfinished" so must need align boring after fitment.
# 636433 Bearing c/shaft frt. (unfinished)
# 636458 Bearing c/shaft ctr. (unfinished)
# 636506 Bearing c/shaft rr. (unfinished)
After-market numbers would be nice - someone!
The Opel Parts book lists the bearings seperately ( no kit!) and they are "unfinished" so must need align boring after fitment.
# 636433 Bearing c/shaft frt. (unfinished)
# 636458 Bearing c/shaft ctr. (unfinished)
# 636506 Bearing c/shaft rr. (unfinished)
After-market numbers would be nice - someone!
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
6A - Engine MechanicalTrying to figure out what the blip is on the hand held tach and you can hear it as well. Keep in mind aside from the little fluctuation on the hand held tach the car is running perfectly with no other symptoms or reactions. Intake manifold recently sanded flat, Carburetor placed on a piece of...
- 5
- 376
-
Will I. Finish · updated
-
6A - Engine MechanicalHi guys so I have been woring on the GT lately. It isn't running perfect but it's running pretty good. I know that the valves are loud and annoying in Opels but my grandpa thinks they might be too loud and we want to adjust the valves so the engine will run good(even with a vacuum leak) and so...
- 9
- 594
-
Young Gt Lover · updated
-
6A - Engine MechanicalHowdy Everyone, So, I just called Fluidampr and spoke to someone who says they don't do custom, short run jobs. I asked about consulting and the person said their engineering department is backed up. I know this could just be getting me to politely go away or it could be their actual position...
- 22
- 803
-
Autoholic · updated
-
6A - Engine MechanicalHey guys I have a question, I'm getting ready to rebuild the oil pump for my 1.1L, pump housing and pickup have been steamed cleaned I have the new gaskets and new gears & spring do I need to use any silicone on either of the gaskets? (pump to block or the pump gear cover/pickup to pump housing...
- 4
- 286
-
6A - Engine MechanicalHi guys my grandpa and I are going to turn over the engine in the GT on Easter. We don't want to use the starter motor in case one of the valves are stuck. Do you just turn the fan or do you get a ratchet and socket? We want to do it manually. Thanks Sam
- 22
- 1K
-
Young Gt Lover · updated
Join now to ask and comment!