Joined
·
127 Posts
Exhaust question
Has anyone tried the idea of tracing the head ports gasket to a piece of 1/4" plate steel and taking it to a mill and getting all the ports cut out. Then just take a passenger side chevy small block header and cut the tubes off at the flange and heat them to bend them to match the GT ports (they are very close to Opel GT exhaust ports) and weld them in.
Has anyone tried the idea of tracing the head ports gasket to a piece of 1/4" plate steel and taking it to a mill and getting all the ports cut out. Then just take a passenger side chevy small block header and cut the tubes off at the flange and heat them to bend them to match the GT ports (they are very close to Opel GT exhaust ports) and weld them in.