[Sparky73]

Sorry about all the Forum posts, but I just got my body kit yesterday, and I go to install it, and its about a 1/2 inch too short (from wheel well to wheel well) The only thing I could think of is that it is cold out, and maybe shrunk it? Please I need help, I dont want to end up breaking the fiberglass!

 

[Sparky73]

It isnt the Front Spoiler, its the side skirts. If I set one side in the correct place, I would have to bend the fiberglass like 1/4 - 1/2 inch to get it to fit, and I dont want to end up breaking it! If you have put in a kit before, did it go right on or did you have to stretch/bend it a little?

 

[Sparky73]

I got the side skirts and the California Edition Front Spoiler from OGTS. It is only the side skirts that don't fit, how hard it this going to be to bend to make fit? Sorry Im new at this stuff

 

[Sparky73]

well its right on the bottom of where the kit goes, pretty close to the bottom of the wheel well too (front of the rear, and behind the front) I hope that helps!