[hrcollinsjr]

I noticed your handle is offset similar to the KM tool. For those with the KM tool or making one there is a reason for them being offset. I've seen some of the KM tools stripped because the shallow side was used instead of the long side.

Nice job! If you stamped the PN in it, I think it could pass for a factory tool.

Harold

 

[hrcollinsjr]

Looks like a custom tool to me. All custom tools are DIY.

Looks like a Kent Moore tool to me, except better made.

I'm talking about the fact that we also have a Kent Moore J tools forum.

Didn't realize that, I'll have to check it out.
Edited title I hope is to everyone's liking? Should make it easier to find for anyone looking for a pinion holding wrench.

Harold