[pvcar]

ok i also just noticed that when i was trying to get my alternator to work that my drivers side motor mount is shot to he!!, looked up price at ogts.com 30 bucks sounds fair to me ill be ordering one of them tommorow morning, just wondering i pulled the engine befor just cant rember if i can just undo the blot on the drivers side mount jack up that side of the engine pull the mount and stick the new one in, without hurting the pasenger side mount?? just wondering also does anyone no if those are repo.'s or are those origanal stock? just my curiosity. thanks again for any advice.

 

[pvcar]

sounds good, welll im almsot positive my passenger side one is in ok condition because i jus did a header and it looks pretty good, but ill double check anyways, thnaks again.

 

[pvcar]

well i orderd a mount for the drivers side today i figure that if my passenger side one looks ok and i also have just put a new heat shield on the passenger one, also something i learned today the drivers side is stressed when the car goes forward the passenger side only gets stressed realy when ur in reverse.

 

[pvcar]

well looking at the mounts today it looks like my engine has been moved over about an inch to the passengers side which means both mounts are broken, so i orderd anthor mount and will be doing both it looks like.

 

[pvcar]

ok i was talked into it i put both motor mounts in they arent that hard to do just jack the engine up by the tranny bell housing pull the old one out put the new on in, let down engine and bolt down tightly, they seem to make there car ride alot better, as well lknow i see why u must let down the engine to take the valve cover off, my mounts were so compressed that i could remove the valve cover with out lowering the engine at all. thanks again for all the help i got from every one.