Opel GT Forum banner
1 - 2 of 2 Posts

· Senior Contributor
Joined
·
499 Posts
Discussion Starter · #1 ·
For those not used to dual Webers I have found they need frequent tightening and checking of nuts. So far in 1000 miles I have shed several nuts. Last night the one of the fuel fitting nuts came loose and sprayed gas all over the side of the carb and then dripped down onto the header. Had the engine not of been cold as I had only gone a couple of thousand yards and I had not shut it down quickly when the engine began to sputter it might have been a real disaster. Every two weeks or so it is a good idea to check that everything is snug.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top