Opel GT Forum banner
1 - 1 of 1 Posts

· boomerang opeler
Joined
·
5,661 Posts
sticking disks

hi all i would have thought that on any sticking disk the first thing to pull would have been the calliper.as you get ware on the rubber rings that seal the pistons they don't pull the pistons back into place and your brake pads then bind
when you bleed the whole systom you should start at the front drivers side (shortest pipe) then the front passenger side then go to the rear finnishing with the cylinder with the longest run this way any air or old fluid cannot get pulled back into apipe nearer the master cylinder
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top