Opel GT Forum banner
1 - 1 of 4 Posts

· Super Moderator
15,409 Posts
It was probably warped before you cut the webs. They usually warp from loose bolts in a previous life...

It can be machined flat assuming it's not too warped. If the flange thickness is reduced by too much, the intake flange may not line up under the heads of the bolts. They should be 12mm thick (.472").

1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.