Opel GT Forum banner

oil pressure sending unit

Jump to Latest Follow
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
where is the oil pressure sending unit located on the 1.9? I want to get an oil pressure gauge reading.
 
G

·
Discussion Starter · #2 ·
Right side of the block, about 4 inches from the back. . . it can be hard to spot with the manifolds in place. Easy to spot without them.
 
G

·
Discussion Starter · #4 ·
No problem, happened to be in the neighborhood at the time. BTW, I´m not saying you HAVE to remove the manifolds . . . it would just be EASIER to get to it without the friggin´ head pipe in the way!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Recommended Reading
Read More
  1. 6A - Engine Mechanical
    I found some thing interesting today that I never noticed before ( if I did I must have said well it's running fine leave it alone) But it now has me very curios. 1, the advance hose off the distributor is going to the tree ( 73 with both advance and retard ports) 2, the retard hose off the...
  2. 6A - Engine Mechanical
    hello GT people im was wondering if my 5w-40 Castrol GTX Magnatec oil will "work" whit my orginal. 1,9s engine and if people could wright their engine oil here that could be a nice way to tjek out whit oil is the bedst ect.
  3. 6A - Engine Mechanical
    A few years ago I replaced the front engine crankshaft seal, apparently without much luck as, I suspect, there is an amount of wear on the crankshaft. Does anyone have a recommendation as to the inside diameter of a Speedi Sleeve that might fit the bill?
  5. 6A - Engine Mechanical
    Howdy Everyone, I randomly came across the below video on YouTube and immediately recognized the similar style of oil pump... While the test to show an improvement is hardly scientific, if the different design improves oil flow it could be worth looking into. The lobe design is similar to...
  6. 6A - Engine Mechanical
    I measured the end of the pulley where it goes through the TC seal on three parts and it measures 1.776", with a groove of + or - a few ten thousandths of an inch.(Mitutoyo digital caliper) I sold it to another site member and he pointed out the groove. I would doubt that a TC seal would create...
Read More
About this Discussion
3 Replies
0 Participants
Last post:
Guest
Opel GT Forum
A forum community dedicated to Opel GT owners and enthusiasts. Come join the discussion about restorations, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussions Member Projects Opel Engine Performance Modifications 6A - Engine Mechanical Engine Swap Forum
Recommended Communities
Community avatar for Alfa Romeo Forums
Alfa Romeo Forums
85K+ members
Community avatar for VWVortex Volkswagen Forum
VWVortex Volkswagen Forum
1M+ members
Community avatar for Chevy Cheyenne Chat
Chevy Cheyenne Chat
NEW!
20+ members
Top