Richmond 6 speed gearbox
1 - 2 of 2 Posts
Joined
·
5,636 Posts
find them at
http://www.richmondgear.com/
i think it will need a big shoe horn to get 1 of them in a gt gearbox tunnel mind
http://www.richmondgear.com/
i think it will need a big shoe horn to get 1 of them in a gt gearbox tunnel mind
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Clutch, Transmission and Drive-train UpgradesInstalling 2005-10 Mustang T5 5-speed into an Opel GT Note: This is still a work in progress. More updates and photos to follow over the coming days. I recently installed a Tremec T5 from a 2005-10 Ford Mustang (aka S197) into my Opel GT and wanted to document the process for others who may...
- 70
- 10K
-
zippy7575 · updated
-
Clutch, Transmission and Drive-train UpgradesI'm doing the upgrade to the S-10 clutch with the new incoming Aluminum flywheel going on the Getrag . . I'm looking at PU1904 clutch. It's for a 2.8 V6 ,85-92.9.125 0D. The company I've been recommended to is ClutchNet from Ca. They say they have 3 stages of pressure plates . 15%higher...
- 89
- 7K
-
Dale .D · updated
-
Clutch, Transmission and Drive-train UpgradesI'm attempting to rebuild the rear end in my GT. It had a lot of slop and whine in it. While I have a "spare" rear end, i also happen to have squirreled away an Isuzu Impluse rear end. The Isuzu 3.90 gear set should work great with the 5 spd. Unfortunately, the rear end had some water in it...
- 40
- 2K
-
Clutch, Transmission and Drive-train UpgradesI installed a Getrag in my GT and I was hearing a noise from the dust cover of the transmission...I used the dust cover from a automatic transmission and thought they were the same....when I took the dust cover off it had heavy scraping on one side.. so I bent it the opposite direction back for...
- 1
- 292
-
jrapose · updated
-
Clutch, Transmission and Drive-train UpgradesI know this topic has been spoken on over and over. It seems that most people tat are building/swapping their GTs have also gone with a rear end swap as well. Other than the obvious power gains and the rear end not holding up..... does nobody make a hardened set of rear axles..? Ultimately it...
- 11
- 930
-
Doc_Holliday53 · updated
Join now to ask and comment!