Opel GT Forum banner

S-10 Clutch & Getrag

Jump to Latest Follow
1 - 4 of 4 Posts
N

·
Opeler
Joined
·
18 Posts
Discussion Starter · #1 ·
S-10 Clutch

Hello everyone! I have just purchased a clutch kit for S-10 and I would like to now if I need to modify anything else besides machining the flywheel flat and readjusting the ball type bolt. I have a Getrag 240 installed. Appreciate your input GUYS!! Cheers!!:D
 
RallyBob

·
Super Moderator
Joined
·
14,151 Posts
#2 ·
For a Getrag transmission, you will have to grind the bellhousing inside to clear the clutch is one area. It will spin over, but will hit and make a lot of noise. The new clutch adjustment should be 4.75" instead of 4.25".

Bob
 
Save Share
Reply
tekenaar

·
Super Moderator
Joined
·
5,298 Posts
#3 ·
Save Share
Reply
1 - 4 of 4 Posts
Recommended Reading
Read More
  1. Clutch, Transmission and Drive-train Upgrades
    The 72 Ascona that I just acquired had a pin drop out of the linkage attaching the shifter to the trans. I'm questioning whether the clip that was holding it is the right one, or if it should just be a standard e-clip like the one on its other end. If it is the correct one, which end faces...
  2. Clutch, Transmission and Drive-train Upgrades
    After reading @zippy7575 's amazing write up on how he installed one into a GT I was confident I could find a way to get one into a Manta. They're basically the same right? Well... only sort of. If you haven't read that thread, stop reading this and read this: How to install a 2005-10 Mustang...
  3. Clutch, Transmission and Drive-train Upgrades
    Finally got around to it and made a bell housing for a Borg Warner T-50 5 speed out of an Omega/Vega. Since it is not possible to just make an adapter I had to make this one from scratch. It all went well but the chamfer at the end of the input spline is a little different and will have to...
  4. Clutch, Transmission and Drive-train Upgrades
    I know this topic has been spoken on over and over. It seems that most people tat are building/swapping their GTs have also gone with a rear end swap as well. Other than the obvious power gains and the rear end not holding up..... does nobody make a hardened set of rear axles..? Ultimately it...
  5. Clutch, Transmission and Drive-train Upgrades
    Type of rear suspension to use I picked up the rear axle assembly upgrade today. It came out of a 91' Volvo 240. It is 3.73 ratio and I believe it's a 7.65" ring gear (Dana 30). The complete assembly cost me $100, and they pulled it! Now I have to decide whether to transfer the spring...
Read More
About this Discussion
3 Replies
3 Participants
Last post:
nosmanta
Opel GT Forum
A forum community dedicated to Opel GT owners and enthusiasts. Come join the discussion about restorations, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussions Member Projects Opel Engine Performance Modifications 6A - Engine Mechanical 2D - Body Repairs and Modifications
Recommended Communities
Community avatar for Mercedes-Benz Forum
Mercedes-Benz Forum
565K+ members
Community avatar for Alfa Romeo Forums
Alfa Romeo Forums
85K+ members
Community avatar for Bronco EV Forum
Bronco EV Forum
NEW!
30+ members
Top